One Down!

 I used up the first bottle of sealant and this coming Thursday I will load the second bottle of sealant in the sealant gun. Even though the process takes much longer than using rubber spray, using the sealant creates a much stronger bond than the rubber spray because of it's glue like texture. In order for me to get the desired results, I have to apply at least as much as it is required to cover a 10ft surface. A Half a gallon would make the hull waterproof as well as more sturdy. There's no such thing as frugal spending when money is needed to get the job done right.





Comments

Post a Comment

Popular posts from this blog

Pinching!

Image
I finished tying down the  "Noodles"  on the bow (front) of the boat. Tomorrow I'll tie down the rest of the"Noodles" that's on the stern (back) of the boat. I'm still adding more adhesive here and there. The "Noodles" are still sticking up, resisting the stress placed on them. Stepping back, what I'm doing really feels surreal.
Read more

Finally Moving Forward!

Image
 Yesterday I finally took the boat out the backyard so I could start working on making a deck for her. What I worked on today was removing the stuffing I packed the boat with. The material, (frond leaves) that I stuffed the boat with was totally unnecessary because the model boat I made totally out of fronds floated extremely well. I was so happy that I finally made the model, after months of trying out different techniques. I went back to the basic fronds and wood glue to construct the model. I had two little helpers who assisted me in testing the model on a small pond. i was so elated that the model float as well as it did. I have to say I'm actually not behind schedule in the launch date for The Auset Fronds. Constructing the boat's deck is the fun part because there's so many things I plan to do to the boat in the completion of building her. I've even found a company that is going to assist me in the patent process. They were really impressed with what I'm doi
Read more

Little Bits!

Image
.I was able to work on the boat over the weekend. I decided to loosen the binds on both ends of the boat. Hopefully the fronds will stay upright. I attached the fronds at the bow with some metal I made into fasteners. I'm plan on doing the same thing to the fronds at the stern of the boat. In order for me to be able to straighten the fronds at each end, I had to raise the boat higher. The next thing is to add more glue in order to seal all the fronds in place, which will strengthen the hull over all. A rubber sealant will then be applied once all the fronds on the outside of the hull is rock solid.
Read more