Turn Out!


 I applied the first coat to the front , center and back of the hull. The "Noodles" are very firmly bonded to the fronds that they are laying on as well as to each other. I think adding two more coatings wouldn't hurt, if anything it would make the "Noodles" bond even tighter. I have to really make sure that they won't become loose in the process of the boat being handle or when it is sitting in the water. I ran very quickly out of the spray on rubber coating in a matter of minutes. I decided to try some liquid rubber sealant to see which method of application would be better. The spray is way easier to apply than using the liquid form but they both actually gave me the results I was looking for.


Comments

Post a Comment

Popular posts from this blog

Pinching!

Image
I finished tying down the  "Noodles"  on the bow (front) of the boat. Tomorrow I'll tie down the rest of the"Noodles" that's on the stern (back) of the boat. I'm still adding more adhesive here and there. The "Noodles" are still sticking up, resisting the stress placed on them. Stepping back, what I'm doing really feels surreal.
Read more

Finally Moving Forward!

Image
 Yesterday I finally took the boat out the backyard so I could start working on making a deck for her. What I worked on today was removing the stuffing I packed the boat with. The material, (frond leaves) that I stuffed the boat with was totally unnecessary because the model boat I made totally out of fronds floated extremely well. I was so happy that I finally made the model, after months of trying out different techniques. I went back to the basic fronds and wood glue to construct the model. I had two little helpers who assisted me in testing the model on a small pond. i was so elated that the model float as well as it did. I have to say I'm actually not behind schedule in the launch date for The Auset Fronds. Constructing the boat's deck is the fun part because there's so many things I plan to do to the boat in the completion of building her. I've even found a company that is going to assist me in the patent process. They were really impressed with what I'm doi
Read more

Little Bits!

Image
.I was able to work on the boat over the weekend. I decided to loosen the binds on both ends of the boat. Hopefully the fronds will stay upright. I attached the fronds at the bow with some metal I made into fasteners. I'm plan on doing the same thing to the fronds at the stern of the boat. In order for me to be able to straighten the fronds at each end, I had to raise the boat higher. The next thing is to add more glue in order to seal all the fronds in place, which will strengthen the hull over all. A rubber sealant will then be applied once all the fronds on the outside of the hull is rock solid.
Read more